pod motors
trend 3.0

discover now

Clear stern, full speed ahead

The underfloor motor is particularly suitable for those who want a clear stern. The motor is located rotatably under the hull, guarantees extremely high maneuverability and frees up the rear of the boat (for example, for bathing platforms). This means that there is no interference with the boat’s design language. A real win-win situation.

€ 3.799

incl. VAT

Trend 3.0UF

Steerable Pod Motor

The heart of the drive is located in the drive housing. Slow-running motors transmit power to the propeller without gears via a stable stainless steel shaft. The stable propeller, which is also used in commercial shipping and submarines, ensures a unique dynamic propulsion. Thanks to the extreme skew, not only enormous thrust forces but also a low noise level was achieved, which means that conversations on board are easily possible. In addition, the anti-cavitation plate prevents air from being sucked onto the propeller, enabling the motor to be immersed to the shallowest of depths. Should you run aground despite being careful, this is not a problem for the energy package. The steering fin is not only highly maneuverable but also has a predetermined breaking point that prevents major damage to the motor. The cast housing is also made of a seawater-resistant aluminum alloy and a 6-layer coating against fouling and corrosion. The shaft is height-adjustable and is much larger than comparable products.

The advantages of the Steerable Pod Motor Trend 3.0

Unrivaled overall efficiency

Maximum smoothness

Unique vibration-damping suspension system for maximum smoothness and ease of installation

Permanently resistant to salt and fresh water

Optimized anti-cavitation plate prevents air from being drawn in, meaning that minimal immersion depths can be achieved

Technical
Details

Motor

Power: 3,000W
Voltage: 48V
Control: Remote throttle
Comparative thrust of petrol outboard motor: 8 HP
Thrust: 169 lbs
Weight: 19.8 kg

Additional Accessories

Frequently Asked Questions

What power is required?

The Outboard Motor Trend 3.0 is suitable for dinghies and smaller boats. In order to have sufficient reserves against wind and waves, we recommend the Trend 3.0 for boats up to 3.0 tons, depending on the hull shape; the Trend 4.3 can be used up to 4.0 tons.

The driving time naturally depends on the capacity and quality of the batteries.
Below are examples with the Aquamot Longlife Deep-Cycle batteries.

Trend 3.0 with 4 Aquamot ALS batteries 12V/260AhTrend 4.3 with 4 Aquamot ALS batteries 12V/260Ah
Partial load12 h 00 min10 h 00 min
Half load06 h 30 min05 h 30 min
Full load02 h 55 min02 h 15 min

Of course, there are many ways to increase or decrease the range. In principle, however, only traction batteries should be used, which have also been designed for higher currents over a longer period (ATTENTION: no starter batteries or semi-traction batteries). In addition, a minimum capacity of at least 110Ah is recommended. All batteries should have the same capacity in order to achieve the highest possible service life. Always ask your Aquamot dealer or Aquamot about the capacity design beforehand.

In general, everything is included in the drive package except batteries and charger. Thus, the Steerable Pod Motors Trend also include the driving lever and on-board computer. In addition, the bracket for lamination can also be purchased. The cable lengths are standardized (3m main cable, 30cm the battery brackets, 6m control cable to the display and driving lever). Cable extensions can of course also be purchased.

The warranty period is 2 years.

Sign up for our newsletter
and don’t miss any
electrifying news

Aquamot Electric Motors
GmbH

Heroalstraße 5
A-4870 Vöcklamarkt
+43 7682 8535
+43 7682 8535 15
office@aquamot.com

Opening hours:
Mon-Thu: 8:00 AM – 4:30 PM
Fri: 8:00 AM – 12:00 PM

Boot Düsseldorf

17.- 25.1.2026
Düsseldorf

Austrian Boat Show

26.2-1.3.2026
Tulln